Garage Door Cable Repair & Replacement

Garage door cables run from the bottom corners of the door up to drums or pulleys, and they're under constant tension. Damp Pacific Northwest air can rust cables over time, and a worn cable can snap or slip off its drum, leaving the door lopsided or stuck.
Because cables are connected to the spring system, replacing them requires releasing and resetting spring tension. Our technicians handle this safely, replace both cables so they wear evenly, and check the drums, bottom brackets and springs while they're there.
Safety first: If a cable has snapped or come loose, don't operate the door. Running it with a broken cable can bend panels and tracks, or cause the door to fall.
Signs of cable trouble
- Frayed, rusty or kinked cables
- Door hangs lower on one side
- Cable hanging loose beside the door
- Door jerks or shudders while moving
- Door went off track after a cable slipped
- Bottom brackets are bent or pulling away
Not sure what's wrong?
Describe the problem and we'll help you figure it out.
Cable services
Cable replacement
New galvanized lift cables sized for your door.
Re-spooling
Cables that slipped off the drum reset and re-tensioned.
Bottom bracket repair
Rusted or bent brackets replaced where cables attach.
Full rebalance
Spring tension adjusted so the door lifts evenly.
Our process
- Secure the door: We lock the door in place so it can't move while we work.
- Release tension: We safely unwind spring tension from the system.
- Replace cables: New cables are installed and wound evenly on both drums.
- Rebalance & test: We reset tension, level the door and test full travel.
Serving your area
We provide cables service throughout Seattle, Bellevue, Tacoma, Marysville and communities across Snohomish County. See all service areas.



